MaxiJet Pump Holders

[Macca]

These are used with MJ 1200s in a Rio 300 with 8mm glass and they hold just fine. I used the bracket rather than stick the MagFloat directly to the MJ as it going to be easier cleaning/maintaining the pump by being able to take the MagFloat off.

Here is the link:Mag Link (http://www.reefcorals.co.uk/forums/attachments/Mag.pdf)

Thanks Campbell for Submitting this info

James

[oakwell]

such a simple idea....great info

[Pinkfish]

I guess if this works for the MaxiJet then it should also work with Seio as well, will give it a try.

Mike

[Pinkfish]

I have just done this with my Seio Powerheads today and it works a treat !!!
Had enough of them allways falling off the glass.

I used underwater reefsafe silicone - which ment in 3 hours was fully set and ready to be placed back into the water.

[leggit]

great idear james , have you seen the new

Sure Grip 100 Magnetic Powerhead Holder

The new way to hold those pesky powerheads in position.

Suits: Powerhead make & Model Glass thickness
Seio Super Flow M620/M820/M1100/M1500 3/4" or less
Tunze Stream All Models 3/4" or less
Maxi-Jet 400/600/900/1200 5/8" and 3/4"

didnt post link as not sure if aloud

carl